RapidCAD

RapidCAD is a specially packaged Intel 486DX and a dummy floating point unit (FPU) designed as pin-compatible replacements for an Intel 80386 processor and 80387 FPU. Because the i486DX has a working on-chip FPU, a dummy FPU package (the "RapidCAD-2") is supplied to go in the Intel 387 FPU socket. The dummy FPU is used to provide the FERR signal, necessary for compatibility purposes.

Despite being able to execute instructions in the same number of cycles as an i486DX, integer performance on RapidCAD suffers due to the absence of level 1 cache and the bottleneck of the 386 bus. RapidCAD offers minimal improvement in integer performance over a 386DX (typically 10%, at most 35%), but provides substantial improvement in floating point operations (up to 80% faster) for which it was marketed. Floating point performance is mostly improved by moving the FPU onto the CPU core. Other source reports that the performance range from 20 to 170 percent faster than the regular Intel386 DX based computers. It was available at manufacturer's suggested list price of USD $499.[1]

  • Intel RapidCAD-1
    Intel RapidCAD-1
  • Intel RapidCAD-2
    Intel RapidCAD-2

Technical specifications

Intel RapidCAD-1

  • Package: 132-Pin CPGA
  • CPU clock: 16-33 MHz[2]
  • Transistors: 800,000
  • Process: CHMOS 0.8 μm
  • Voltage: 5 V
  • sSpec: SZ624

Intel RapidCAD-2

  • Package: 68-Pin CPGA
  • CPU clock: 16-33 MHz[3]
  • Transistors: 275,000[citation needed]
  • Process: CHMOS
  • Voltage: 5 V
  • sSpec: SZ625

See also

References

  1. ^ Intel Corporation, "New Product Focus: End User: CAD Programs Blast Off With Engineering Coprocessor", Microcomputer Solutions, March/April 1992, page 10-11
  2. ^ Intel Corporation, "New Product Focus: End User: CAD Programs Blast Off With Engineering Coprocessor", Microcomputer Solutions, March/April 1992, page 10-11
  3. ^ Intel Corporation, "New Product Focus: End User: CAD Programs Blast Off With Engineering Coprocessor", Microcomputer Solutions, March/April 1992, page 10-11