Physical system of measurement that uses the metre, kilogram, and second as base units
The metre, kilogram, second system of units, also known more briefly as MKS units or the MKS system,[1][2][3] is a physical system of measurement based on the metre, kilogram, and second (MKS) as base units. Distances are described in terms of metres, mass in terms of kilograms and time in seconds. Derived units are defined using the appropriate combinations, such as velocity in metres per second. Some units have their own names, such as the newton unit of force which is the combination kilogram metre per second squared.
By the mid-19th century, there was a demand by scientists to define a coherent system of units.[4] A coherent system of units is one where all units are directly derived from a set of base units, without the need of any conversion factors. The United States customary units are an example of a non-coherent set of units.[5] In 1874, the British Association for the Advancement of Science (BAAS) introduced the CGS system, a coherent system based on the centimetre, gram and second. These units were inconvenient for electromagnetic applications, since electromagnetic units derived from these did not correspond to the commonly used practical units, such as the volt, ampere and ohm.[4][6] After the Metre Convention of 1875, work started on international prototypes for the kilogram and the metre, which were formally sanctioned by the General Conference on Weights and Measures (CGPM) in 1889, thus formalizing the MKS system by using the kilogram and metre as base units.[7]
In 1901, Giovanni Giorgi proposed to the Associazione elettrotecnica italiana (AEI) that the MKS system, extended with a fourth unit to be taken from the practical units of electromagnetism, such as the volt, ohm or ampere, be used to create a coherent system using practical units.[8][6] This system was strongly promoted by electrical engineer George A. Campbell.[9] The CGS and MKS systems were both widely used in the 20th century, with the MKS system being primarily used in practical areas, such as commerce and engineering.[4] The International Electrotechnical Commission (IEC) adopted Giorgi's proposal as the M.K.S. System of Giorgi in 1935 without specifying which electromagnetic unit would be the fourth base unit.[10] In 1939, the Consultative Committee for Electricity (CCE) recommended the adoption of Giorgi's proposal, using the ampere as the fourth base unit. This was subsequently approved by the CGPM in 1954.
The MKS units with the ampere as a fourth base unit is sometimes referred to as the MKSA system. This system was extended by adding the kelvin and candela as base units in 1960, thus forming the International System of Units. The mole was added as a seventh base unit in 1971.[6][7]
^Arthur E. Kennelly (1935), "Adoption of the Metre–Kilogram-Mass–Second (M.K.S.) Absolute System of Practical Units by the International Electrotechnical Commission (I.E.C.), Bruxelles, June, 1935", Proceedings of the National Academy of Sciences of the United States of America, 21 (10): 579–583, Bibcode:1935PNAS...21..579K, doi:10.1073/pnas.21.10.579, PMC1076662, PMID16577693