The station was designed by the Austrian architecture firm Architektengruppe U-Bahn[2][3] and opened in 1985 as "Joyce station" on the original Expo Line. It replaced Joyce Loop, located 600 metres (2,000 ft) south at the intersection of Joyce Street and Kingsway, as the main transfer point for local transit services in the area. Trolley wires were extended to the station in early 1986 to bring trolley buses to the station's bus loop.[4]
Formerly an industrial area, the immediate vicinity of this station has since been redeveloped as Collingwood Village, a denser community of high-rise condominiums. The "Collingwood" portion of the name was added in 2001 in an attempt to reflect the positive impact of SkyTrain on the surrounding community.
As part of Expo Line upgrades, renovations on the station began in early 2016.[5] Phase one of the project was completed on October 6, 2017; it included a replacement of the existing elevator, the installation of two new escalators at the east end of the platform to replace the original single one, and the improvement of the station design and integration with the surrounding community.[6] Phase two renovations began in early 2018 and were completed on June 15, 2019.[5][7]
West entrance : located on the west side of Joyce Street, in the centre of the bus loop. The entrance is fully accessible with an elevator and an up escalator.[9]
East entrance : located on the east side of Joyce Street, on the opposite side of the bus loop. The entrance is also fully accessible, including up and down escalators, an elevator, and a staircase. This entrance serves the passenger drop-off area.[9]
Joyce–Collingwood station provides a partial off-street transit exchange at the intersection of Joyce Street and Vanness Avenue. Bus bay assignments are as follows:[10]
.jpg)
.jpg)
.jpg)
