If pulled with one hand holding one end, the other hand holding the start side of the loop that is the continuation of the same end, [clarification needed] before tightening the knot of the loop, it may capsize to a slip knot with a complicated and heavy knot.
It is tied on one hand to make a loop about twice the size of that hand (use fingers for a smaller one, thumb-hook-to-elbow for a large one), as follows:[3][4][5]
start with the rope 3 times around the palm of one hand, let the ends hang down,
then pull the initial middle turn up from the top edge and place it over to the right (of the right loops top edge)
then pull the now new middle turn up from the top edge and place it over to the left
then pull the now new middle turn up from the top edge and place it over to the right
then pull the now new middle turn up to form the loop, dress and tighten before use
The knot is a good one on all three counts—lead, security, and strength. Moreover, the method of tying is both ingenious and distinctive, and once mastered, it is not apt to be forgotten.
To tie: Take three turns around the left arm or hand, according to the size of the material being used. Move the center turn to the outside three times, as indicated by the arrows, first right, then left, and finally right again. Finally, pull out (extend) the center turn, and the knot is ready for use.
^Riley, Howard W. (January 1912). "Knots, Hitches, and Splices". The Cornell Reading-Courses. Rural Engineering Series No. 1. 1 (8). Ithaca, NY: New York State College of Agriculture at Cornell University: 1438. Retrieved 2011-11-08. As collected in Documents of the Assembly of the State of New York, 136th Session, 1913, Vol. 19, No. 29, Part 5.