Fersit Halt railway station named after the nearby hamlet of Fersit (Scottish Gaelic: Fearsaid Mhòr), was situated close to Tulloch railway station in Lochaber, Highland council area, Scotland. Fersit was a remote rural temporary private halt at the north end of Loch Treig where workers were housed who worked on the Lochaber hydroelectric scheme. The halt was opened in 1931 by the LNER, it was located near the site of a contractors railway ballast siding.
The original contractors for the line, Lucas and Aird, had constructed a ballast siding at Fersit and several additional sidings were added in the 1930s. The Lochaber Narrow Gauge Railway was built to facilitate construction and this ran into the Fersit sidings area and ran as far as the Loch Laggan dam works.[6]
Loch Treig dam raised the level of the loch and it serves as the principal reservoir of the whole Lochaber hydroelectric scheme. About 1000 men were employed on the construction of the dams until completion of the project in 1934 and those working at Loch Treig were housed at Fersit that lay roughly equidistant between the dam sites. The main contractor was Balfour Beatty & Co. Ltd.[7]
Constructed in 1930 by Balfour Beatty, the Treig to Laggan railway branch line ran from the Upper Works Railway some 3.25 miles (5.23 km) to Laggan Dam on Loch Laggan, crossing over the Fersit section of the West Highland Railway on a timber trestle bridge that was later replaced by an earth embankment.
Infrastructure
The halt was composed of a single platform on the western side of the line to the south of the present over bridge and parts of this remained in place as late as 2016. The narrow gauge line had loading and access sidings that lay parallel to the standard gauge served cement shed and entered the store and fitting sheds. A single LNER cottage stood to the east of the through standard gauge line.[8] The halt is marked on the 1934 OS map of Lochaber.[9]